Set Cv Out

The Rack Extensions “Set Cv Out” allows you to route the Cv signal from the
In to the 8 Out. The program is selected with the “Switch Up Down Prg”, while
the relative 8 Out is enabled with the “Switch Up Down Set”. When the “In Cv”
(mode slave) is connected, the program change takes place through this
connection, while the “Switch Up Down Prg” is disabled. The same signal as
applied to the “Cv In” comes out of the “CV Thru”. If the “Memo” switch is
activated (green led on the back panel), the relative Outs keep the same
value as the previous selection. If the “Memo” switch is disabled, the relative
Outs not selected have the value set with the “Fix” knobs (back panel).
The “Switch Clean” sets the Outs not selected and with Memo On, with the
relative “Knob Fix” values.
Version 1.1.1 implements high graphic resolution

• 1 Switch Up Down Prg
• 1 Display Prg
• 1 Led Slave
• 8 Switch Up Down Set
• 8 Led Set
• 8 Label text
• 1 Switch Clean Memo
• 3 Cv Input
• 3 Cv Thru
• 16 Cv Output
• 16 Switch Memo
• 16 Knob Fix